M_Body_Coupe
Well-Known Member
Sorry, I of course meant 'per inch of bore size' given that folks can have varying bore sizes.
For me that ended up being 0.018" for top ring, and 0.020" for the second ring.
this is what i'm busy with
- Thread starter 9secRR
- Start date
For me that ended up being 0.018" for top ring, and 0.020" for the second ring.
9secRR
Well-Known Member
that's what i thought but wanted to make sure. i have Dykes rings so that might be different gaps then standard or gapless?
9secRR
Well-Known Member
Waiting for a friend to get back from holidays. He has a set of 1.75 ratio rockers I want to try.
9secRR
Well-Known Member
New slicks for the 2024 race season.
Today might be the day to fire up the 416” on the run stand. If everything goes well it’s off to the dyno
Today might be the day to fire up the 416” on the run stand. If everything goes well it’s off to the dyno
9secRR
Well-Known Member
The old blue beater is ready to make noise. The weather is not cooperating today to fire up the 416” so i decided to get my car ready.
M_Body_Coupe
Well-Known Member
"Mission Accomplished", eh? Nice...
Yeah, weather is a bit crappy here today too...I had muscled in my 1" rear sway bar earlier on in the week (to replace the 3/4" piece that was in there), and decided to set up the geometry a little better, meaning: end-links and bar at 90deg. angle.
Went shopping for a replacement bolt (what I already had in my Coupe was aftermarket with poly bushings), turns out I need 10" length and good luck finding anyone around that carries that.
So given that the longer bolt wasn't an option I just decided to eek out as much as I could out of the existing setup, just needed to get longer sleeves that separate out the upper and lower sway bar bushings...so while I managed to prime them yesterday, the rain today hasn't helped!
LOL...best to you, would love to hear that thing "sing" in-person though!!! What a ride...
Yeah, weather is a bit crappy here today too...I had muscled in my 1" rear sway bar earlier on in the week (to replace the 3/4" piece that was in there), and decided to set up the geometry a little better, meaning: end-links and bar at 90deg. angle.
Went shopping for a replacement bolt (what I already had in my Coupe was aftermarket with poly bushings), turns out I need 10" length and good luck finding anyone around that carries that.
So given that the longer bolt wasn't an option I just decided to eek out as much as I could out of the existing setup, just needed to get longer sleeves that separate out the upper and lower sway bar bushings...so while I managed to prime them yesterday, the rain today hasn't helped!
LOL...best to you, would love to hear that thing "sing" in-person though!!! What a ride...
