Recent content by 68HemiRR

This is a Norgren Water Trap & Air Pressure Regulator. I used it for many years until I closed my shop. It always worked fine. It does need the glass replaced on the pressure dial. $50.00. Local pickup, or buyer pays shipping.

This is a Dual Feed Chrome Fuel Line. I used it on one of my Offenhauser, AFB dual quad setups back in the day. It is in good condition. $20.00. Local pickup, or buyer pays shipping.

This is a Old School Center Cap for A Keystone Mag Wheel. It includes the inner retainer and screw. It measures 3" diameter at the base and 2 1/2" in depth. It has some pitting so it is not show quality, but maybe someone can use it. $15.00. Local pickup, or buyer pays shipping. (I only have one)

This is a Vintage Parker Cutlery Boot Knife. It is surgical steel Japan. I've owned it for over 40 years. It is in good condition. $50.00. Local pickup, or buyer pays shipping.

These are Two Aftermarket Gauge Brackets. The single one is new, and the triple one is used. The holes are about 2 inches. $10.00 for both. Local pickup, or buyer pays shipping.

This is a pair of 1980's Exhaust Manifolds #4173166 & #4173156. They come off of a 1988 Plymouth Gran Fury Highway Patrol car that we stripped and turned into a stock car. It had the HP 318ci 4bbl engine. They are in good condition and have the AIR pipe caps on the end of the manifolds, which...

This is a OEM Mopar 1970's Ignition Lock Cylinder w/key. This came out of a 1973 Charger SE with a tilt column. It may also be correct for other years and models. $15.00. Local pickup, or buyer pays shipping.

This is a OEM Four Nipple Vacuum Port. It Came off of a big block Mopar, but should work on small blocks too. $15.00. Local pickup, or buyer pays shipping.

All Leather Carpenter's Tool Belt/Pouch. Any carpenters out there that can use this tool belt/apron. It is all leather, including the belt. Not cheap nylon. I bought it new over 30 years ago, and barely used it. It is in very good condition. $20.00. Local pickup, or buyer pays shipping.

This is a Pair Of OEM 1964 to 74 Chrome Door Lock Knobs for A-B-C bodies. They are original, not china knockoffs, and are in good used condition. $10.00 Local pickup, or buyer pays shipping.

This is a pair of OEM 1970's Outside Door Handles #3882626. They are original, not china knockoffs. They came off of a 1973 Charger SE. I'm not sure what all years and models these work on. They are not mint, but are in decent driver condition. $30.00. Local pickup, or buyer pays shipping.

This is a pair of OEM Big Block Mopar Rocker Arm Shafts. They are original Mopar, not cheap china knockoffs. They are in good condition, just could use a cleanup. $35.00. Local pickup, or buyer pays shipping.

This is a set of Four Mopar Trans Cross Member Bolts & Nuts. They came out of a 1969 Roadrunner many years ago, but I'm not sure if they were OEM to that car or not. They should work on most Mopars of that era. They are about 3 1/2" x 1/2" shaft, and are in good condition, just could use a...

This is an Old Automobile Cigar Lighter. I don't remember what it came out of, but you know it's old because it has "lighter" spelled out instead of an icon of a cigarette burning. :-) $10.00. Local pickup, or buyer pays shipping

This is a Pair Of 3/8 Drive Air Ratchets. They are in good condition and work fine. $40.00 for both of them. Local pickup, or buyer pays shipping.