80mirada's latest activity
-
Billy Joel’s motorcycle shop, North Shore of Long Island -
80mirada reacted to Justwondering's post in the thread 3D Printer - 5.8 ft x 1.9 ft x 1.9 ft output with.Here we go... BIG-180x – Modix Large 3D Printers Just $15,500 plus shipping Then there's those pesky taxes. Need some filament. Runs...
-
Did some preliminary measurements and looks like the mount and yoke are very close to factory position. Should not need excessive...
-
Well, been acquiring parts for the next phase of Modoba. Started the 408 engine build, but it's on pause until we get moved into the...
-
80mirada replied to the thread Random Pics.i put the summit 727 pan on my 518, I had to shorten the filter adapter to get the filter in the right place. I like the way the drain...
-
-
80mirada replied to the thread 80 Mirada,.I just spent my weekend trying to get my aftermarket oil pressure gauge to work corry, turns out the dash speaker was causing it to...
-
You're going to spend a small fortune on retrofit roller lifters. Too bad it's not an 85+ block.
-
80mirada replied to the thread 318 roller cam.The lifters are fed from oil galleys that connect the lifters bores.
-
80mirada replied to the thread Firm Feel Products.No, but they sure are pretty
-
80mirada replied to the thread 80 Mirada,.They had 250,000 miles of questionable maintenance, and were put against a cam with a lot more lift than stock. They were pretty sticky...
-
80mirada replied to the thread Firm Feel Products.Mine came yesterday, the finish is exceptional. They are quite beefy, can't wait to install them
-
My 300# t-bars are en route TBKFMJ14 F,M,J-Body Torsion Bar Kit w/ Urethane Bushings 1-1/4" Subtotal 1,200.00 SHIP Shipping and...
-
Test fitting.
-
