Recent content by armataz

still waiting for the distributer, but I'll get busy on swapping out the intake and carb this weekend, I'll also re gap he new plugs to .055.

yours is better than some I've seen saved, I had a bad roof on a monte carlo landaugh, and I used truck bed liner to re-do the vinyl section tacked down some fiber cloth and painted over it, then did the same to the underside to seal it from further damage.

got the intake and carb , still waiting on the distributer to be built. funny thing, brand new carb states, burning ethanol fuel voids the warranty. LOL

the SE might still make a good custom build if some one is interested. stick in a duster dash kit from year one and some scrap yard buckets. it has a steering column stripped 225 and trans I wont be using.

pulled the seats, wire harness, heater box and most if the plastic out of the SE and I have all the melted parts out, I just need to pull the speedo cable and burnt harness out. to start putting the service wagon back together looks like early summer and it will be back to work. I'm driving...

Offenhauser Single-Quad Intake Manifolds 5270LK Intake Manifold, Single Plane, Aluminum, Natural, Square Bore, 4-Barrel, Chrysler, 170, 225, Slant Six, Each Part Number: OFY-5270LK 3.15 out of 5 stars ( 13 ) In Stock (more than 10 available) Estimated Ship Date: Today Free Shipping...

Home / Distributors / Dodge Distributors / Dodge Tri Power / Dodge Slant 6 Tri-Power Distributor Dodge Slant 6 Tri-Power Distributor $365.00 **Current Estimated Shipping Time For This Distributor is 8-10 Weeks** The Tri-Power Advantage Easy Three Wire Hookup Small Diameter Design Performance...

decided to just upgrade the 225, I ordered an offenhouser intake, and an eddlebrock 600 cfm carb, I also ordered a new distributor, for better spark.the distributer, is custom order, for the 4 bbl set up. new plug gap will be .055 it will be a while yet befor I have time to install the parts...

I dont know about rubber flooring, but I removed the carpets from my service wagon, and covered the floor pans with dupli color's truck bed paint. so I can just hose it out, and block/prevent rust

I'm just hoping that they start repopping parts/panels for them, before they are all gone.

650 Hp,440. in a volare'.. Twister to the max. I wonder how he boxed the frame to keep the torque from snapping off the body.

LOL dont blame you. I would not be either .. I, just tossed it out as an option to achieve your stated goals. ;-). I'm starting to look towards the land of OZ. they have a lot of performance parts for my 225 slant six. I've had a really hard time in oregon finding a V8 donor car to do an...

sorry, that would be the block number. the vin, just gives the engine it is suppose to have. it is perfectly legal to swap an engine, as long as it is emissions Complient to the vehicle though.

the world really, as there are members from mexico and the EU also. it's cool seeing the physical differences in options on the cars. and also the different models available in other countries..

just LOL, dont try to find them north of california. ;-),, I've been striking out. I think grave yard cars is buying every pre 90's mopar in this area with a V-8. good luck, and welcome TAZ