Recent content by CM360

Thanks

Thought there is a difference with Volare/Aspen spoiler from 76-80. Found one and its listed as 76-80. Thought that the 1908 spoiler is different? Any help? THX

Thanks John.

Why reinvent the wheel if an easier solution is available. I saw a guy post on utube that the Schumacher /6 to SB has a lot of flaws. I'm building a 10.0 index class car and don't want to run into snags and not be ready for 2025.

Will an A body motor plate fit F or M body?

Any repro or aftermarket sideview mirrors for an '80 Aspen? The car that I recently purchased only had 1. The passenger side is missing.

no preference.

Is there a direct fit Borgeson P/S unit for the M body? Upgrading for a daily driver. I'm looking to remove that sloppy factory unit and make the steering much more predictable. I saw something for SB but not the 225. Thanks

Where is that post? Looked in the suspension section and didn't find it. THX

Thanks foe that info!

There are some A body TRW ball joints that can give you more camber adjustment. Looking for the same results.

My main concern is the outside body/styling and whether its easy to tell the years apart. Hard to find an '82 that's not a rust bucket. The info supplied by AHBGURU is greatly appreciated.

This there a better ball joint( more adj) than the TRW JBJ7016? Getting ready for the fall maintenance . THX

2 Door arm rests from 1976 to 1980 F or M car. PM me here.

I'm looking for a 1982 Grand Fury for a special project(no not a cop car). Looking at early and later models they all look the same to me. Probably only interior/exterior trim packages? Any help?