dkamp's latest activity
-
Ddkamp replied to the thread Fuel Sender Sock..With the sock touching the bottom of the tank (and the metal tube at least 2" from the bottom), and approximately 1.5 Gal added to the...
-
Ddkamp replied to the thread Fuel Sender Sock..The sock is touching the bottom, the metal tube is about 2 1/2" to 3". with an empty tank, I added 1 1/2 Gal, as soon as I get my gauges...
-
Ddkamp replied to the thread Fuel Sender Sock..So if any part of the sock is in gas you might not actually get gas. This means I need to drop the tank again to get the end of the tube...
-
DOn a Fuel sock, if it is pointing down at a 45 degree angle, will it suck gas at the bottom of the tank as the sock is exposed to No...
-
Ddkamp replied to the thread TorsionBar End Bushings.I had it aligned and it runs true and straight. The Alignment guy said he has seen a few Poly Pivot Bushing that did squish and leave a...
-
Ddkamp replied to the thread TorsionBar End Bushings.Thank you Camtron. I feel better knowing that it will not affect my alignment. I have another non related question related to torsion...
-
Ddkamp replied to the thread TorsionBar End Bushings.On My install, the end bushing #1102 was not on the fun category for the install. The #1100 pivot bushing was easier, but I had some...
-
-
Ddkamp replied to the thread The trouble with the FF Torsion bars....Valare 1977, thank you for taking the time to respond, I sure was hoping that there is/was a resolution. I hope one of the others that...
-
Ddkamp replied to the thread The trouble with the FF Torsion bars....I hate to resurrect an Old Thread. I replaced the End bushings, and Pivot bushings, (Polybushings.com) after a few miles of testing, I...
-
-
Ddkamp replied to the thread TorsionBar End Bushings.I talked to Johnny at PolyBushings and he advised to cut with a Hack saw Long ways, then make sure the split is not pointing Up or Down...
-
Ddkamp replied to the thread TorsionBar End Bushings.I drilled and split my metal casings, cleaned off the old rubber with a small wire wheel. I did not drill and remove the end from the...
-
DI am in process of obtaining polybushings #1100 and #1102 I dont understand and hope someone can help me, I've read so many posts...
-
Ddkamp replied to the thread Alternator Bearing replacement question.Vaanth, Thank you very much for that lesson. This is exactly what I was hoping for. This should be part of a "How To" article. I have a...
-
DOn a square back alternator, when you press in the new bearings, how do you know how far to press them on?
