This is a low mileage Steel Cranshaft 1972 340HP. Most I have seen are
cast BUT this is a factory original steel crank engine! It has the correct hole
for a bushing for a 3 or 4 speed. Naturally it can also be used with a Torqueflite
as well.
It has been sitting in a shop for 45 or 50 years...
These in our testing were absolutely the best production Header on our Stock and Superstock
A engine race cars. We always ran the and set National records with them for years.
Unfortunately, when Hooker changed hands they discontinued them and specialized in high volume
budget street stuff...
I was Number 1 Qualifier at NHRA Winternationals today in Superstock.
1980 Aspen Coupe SS/NA with a stock compression/Thermoquad
low performance 318 V8 that can run 10's @ 120+ MPH at 3600 Lbs.
Former Paul Rossi/Larry Harrell that was never driven on the street with only
27 Original Miles. It...
Since NHRA changed the rules
to penalize what use to be performance
classes, we do not have much choice!
Next NHRA will probably give everyone a
Wally for just participation.
Jon won D/SA in his 340 71 Demon
AND
I won N/SA in his Old 78 Aspen 318 Wagon (Small Valve 1.78/1.50)
over several well driven Small Block Chevrolets.
John faced our friends in the Loge and Stein 69 440 Dart GTS
in the finals. They ran 10.65 @ 122 in the heat (Close to 100 and
Humid). Jon ran...
Metering rods/Hangers and all related hardware.
Bowl Vent. Accelerator pump and pieces. Some other
stuff as well.
I have sold much nice for less (I still own over a 100)
than it brought.
I need a trim piece that goes around Pass headlight
on my 78 Aspen. I believe they are the same on all
76 to 79 F Body cars but I am not sure,
The one I have as a small ding in it.