Recent content by MBDale

Factory light run with a single prong oil pressure switch, with a gauge.

Find glass yet??

Hey guys, Hope everything is well. Came across this today with some other interesting things. Just thought I’d throw this at the team for a double check on what it belongs too. Thanks!!

Just going to clean up the backing plates a bit more and it’s ready.

So about 2 1/2 inch wide steel channel and grind whatever down you need 7177rr?? That’s what I’m envisioning.

Thanks Bud W and Barbee6043. Just cleaning up undercarriage today. I’ll order the tube wrap.

Time for a bit of an update. Been at home and catching up on things. Started a bathroom renovation which quickly expanded into the main floor of my house. Started about Christmas, just small stuff left. Been on the car lately too. Put new upper control arms in. Also finishing up some welding...

On the topic of heads, with a stock 2.02 J head using stainless steel,swirl polished nail head valves, would that raise compression over stock steel valves?

I’ve got relatives in Uppsala.

Ya, the car was in an accident. Very minor. Pushed the hood in a small amount, the front drivers side fender headlamp bucket and the part of the fender behind the headlight was pushed in. I welded one in from another fender and got another hood. Engine bay and rad cradle is straight and no...

Great thread! These are a pain to change. Mine was a few drips, I took it out to change it and over a year later stuff is still apart. But then I decided on a new pan. Good luck brother!!

Just pull the motor.

The 5th ave video is a good one. Good luck on the swap, grab that truck!! I’ve got a 1980 Volare 2 door I might magnum swap. Slant 6 out, 5.9/46RH in! I’ve met a guy who 5.2 magnum swapped a ‘69 Dart and gave it to his daughter. Even put a command start in!!

This is what I’m running.

After reading some of this I’m beginning to think I’ll just keep the thing. Paid $75 for it.