Recent content by mshred

  1. M

    Pulling switched power from factory fuse block

    Yes, that is correct. On a 77 aspen J2 *Blue which is IGN 1 comes from the ignition switch, but J3 *Brown begins at the starter relay, not at the actual ignition switch...thus, my concern is if I tie them together, then there may be a backfeed to the starter when key is in run. I have to test...
  2. M

    Pulling switched power from factory fuse block

    The instructions only show for older chryslers while KEEPING the factory electronic ignition box, which I am wanting to eliminate.
  3. M

    Rear suspension options for an F body wagon ?

    Bit of thread revival here, but OP, what did you end up going with for your wagon? Did you ever get it to the track?
  4. M

    Pulling switched power from factory fuse block

    Has anybody in here that has responded so far adapted a CD ignition box like an MSD in place of the factory electronic ignition in an F-body 1977 or later?
  5. M

    Pulling switched power from factory fuse block

    So my radio wire going to the fuse box is not being used. This is 5 amps, and shared with a 20 amp fuse that powers the a/c clutch, turn signal, and back up lamps. Is this wire and 5 amp fuse in its place sufficient to provide switched power to a relay that will then send power to a small clean...
  6. M

    Pulling switched power from factory fuse block

    Aren't those for blade style fuse blocks only though? If I recall my 77 would use glass fuses still
  7. M

    Pulling switched power from factory fuse block

    What is that triple bullet connector for?
  8. M

    Pulling switched power from factory fuse block

    1977 Aspen, looking for a slot to pull switched 12v power, but there are no empty slots. What slot should I piggyback from, and how are you guys doing it?
  9. M

    1977 Aspen Ignition wiring diagram help- Searching for switched 12v power

    Can anybody tell me if there is a switched power source in the factory fuse panel to tap into?
  10. M

    Ballast resistor wiring

    Thank you!
  11. M

    Ballast resistor wiring

    Doing a bit of thread revival here, but any chance you could post page 5 from the 77 FSM? Looking for the ignition switch wiring and wondering if based on this diagram it would be on there?
  12. M

    1977 Aspen Ignition wiring diagram help- Searching for switched 12v power

    But only in "run" if I am not mistaken. The ignition box would need switched power in start as well.
  13. M

    1977 Aspen Ignition wiring diagram help- Searching for switched 12v power

    I have been going through the harness on my 1977 Aspen wagon, removing parts of it that I don't need, and ensuring that all the wires and connections are good and clean as this is going to be a regular family hot rod in the warm months. I have converted to a Mallory electronic ignition box, and...
  14. M

    Apen Wagon rear tire suggestion for 15x7 rims

    I have 275/60/15's on mine. For some reason, the pic won't upload
  15. M

    77 or 78 FSM wiring diagram

    Going to bump this for you, as I am search of the same thing!
Back
Top