Got the transmission back. I ended up screwing it up by cutting the driveshaft too short and obliterating the rear bearing. Since I had to take the transmission I decided to take the engine out and redo the engine compartmen.
Added an M body cop car rear sway bar to my J body Cordoba. The dimples to locate frame rail mounts were right there. Since im running an 8&3/4 I had to use an e body mount to locate the sway bar endlink. On my two mile trek, I immediately noticed a considerable change in the handling of the...
Latest update. I got the transmission installed and running. I took it out for a test drive. Got two miles and the trans went out. Got to take it out again! What a pain in the ass. Might have been my fault because I originally cut the driveshaft too short but not certain. I put a new shaft in...
Well it’s all bolted in however I’m missing a few parts for my HGM trans controller that I need to order. Also it’s been raining the past few days so I had to pause any progress on the install
Latest update. I was able to MacGuyver the linkages by extending the rod by about 2.5 inches! A trip to Harbor freight and Home Depot provided the tap and dye set and the threaded rod and couplings. So far it works great! I can finally install the trans now! Plan an working on it in the next...
Thanks! Not bad for my first attempt! I had it professionally upholstered but I made the base. When I was still in the guard I had my friend in the machine shop waterjet the aluminum center section.