Search results for query: *

I'm intending to spend tomorrow installing a "Ramchargers Hood Scoop" on my 79 Aspen RT. I recently noticed a rather elaborate network of bracing on the bottom of the hood near wear the hole has to be cut. Is there anything I need to know or watch out for? Obviously body work is not my strong...

I recently got the 360 off my engine stand and installed in my 79 Aspen RT. The instructions supplied with the new headers say to remove the oil filter for installation clearance. Seemed simple enough until tried to install one. The Mopar Oil Filter at 3 1/2 " diameter won't fit between the...

Alright guys and gals, as promised some updates and photos of progress. Rear axle and suspension is in. Interior is complete and I spent today installing the fresh 360.727 trans goes in tomorrow and should be in motion soon !(I hope !) Still need to measure and source a driveshaft to tie it all...

I bought 2 high back style "bucket seats" for my 79 Aspen 2 Dr. Upon removal of the OEM bench seat I found that the floor pans on both sides are not the same height. Apparently the mounting for the OE bench had corrected for this with only outside mounting points. I believe I can make the...

Has anyone attempted to adjust the power booster pushrod to master cylinder length on a 79 "F Body" ? I can't find any specs in the appropriate service manual and most of the posts seem to have a lot of guess work. Any procedures and spec is appreciated!!

I'm ready to lower the completed 360 and fresh 727 into my 79 Aspen RT. Has anyone tried to lower them in together ? The Transmission on the jack won't quite clear the rockers , so I'm hoping to find an alternate solution.

Thanks for accepting me and don't let the Infiniti name scare anyone off. My retirement from Nissan/Infiniti was proceeded by several years as a technician in a Dodge Dealer as well as several seasons in an AHRA Super Stock Dodge Charger. (Guess that dates me by a little !!) My current project...