Search results

column shift tilt thats falling apart. Part of the reason it is getting retired

This one was butchered before I got it.

No seat medallians and blue interior

yes but some parts were missing when I got it and I never fixed it

I'm planning on parting out a 1980 volare wagon and wonder if there are any parts others might want. pm me or post your list and I'll see what I can do.

I need the arms, ball joints and bushings. If the ones in the arms you have are not bad, I'll just use those, but if they are failing I guess I'll have to get new. I'm not planning to drive this car long term, just need it to last a few more years.

If you have both the other one is almost rusted through as well. What do you want for them?

I was driving home and less than a block from home my left upper control arm broke just inboard of the ball joint. does anyone have one they would part with? I live in York, Ne. (at the intersection of I80 and Highway 81)

I would say I'll want the whole assembly for both sides. Have you had a chance to get a shipping quote yet?

Have you had a chance to get a quote? If shipping isn't crazy I'd get the whole spring packs.

Just need the main leafs but the rest could come in handy. Both of my spring packs have sagged badly mostly out near the front eye.. Thank you.

I tried looking up Calvert Racing and didn't get anything to do with leaf springs, do you have a link?

I was hoping they made center bolts with heads big enough to fill the hole in the isoclamp perches. I guess I'll have to come up with a filler to reduce the hole size. Bud W. nice looking car! The springs on my car have much more reverse curve behind the eye than yours. How are you planning to...

The last 6"-8" are bowed to the point that if you put a straight edge on top of the main leaf 12" back it would go over the eye on the end of the leaf. The bolt I'm looking for would have a head that properly keys into the hole in the spring perch that the rubber of the isopad keyed into, so...

how much part and shipping to 68467?

I need a pair of main leafs for an '80 Volare wagon. The front eye has rolled down till the leaf almost lines up with the top of the front eye. I am also converting away from the "isopad" setup. I have the plates and u-bolts but still need the center bolts with the right head size. I have an...

Thank you!

No one has access to an isopad axle to measure the locater hole diameter?

Thank you, I'll have to wait till someone chimes in with the answer or set up an assortment of options and hope for luck.

I need the size of the center hole in the spring perch that is welded to the axle tube. the spring plates that I got are the part numbers listed earlier. Dave

I have the plates now, Thanks to all for their help. One more question, what size is the hole in the spring perch the isopad and center bolt went in? I want to get spacers for them before I take my wheels out of commission. Thanks again!

I need a pair of shock plates that are from an 8 1/4 rear axle but could also be from an 8 3/4, part numbers are 1856346 & 1856347.

I'll look for the helper springs. I went to napa for the shock plates and they could not find them, any one have a part number?

I do not think I have any interest in the iso clamps but the helper springs could be just the trick I need. what do you want for them shipped to York, NE 68467?

I can't afford to put the car down for long ( my only working set of wheels ) but there is a lot of rust so air/ coil over shocks are probably out. I need to look into the shock plates because BOTH iso clamps have rusted out. I should post my emergency repair when I get a chance! I used a piece...