Search results

  1. MiradaCMX80

    1980 Exterior Door Handle

    My driver's side exterior door handle broke. Looks like someone had previously welded it back together. Ebay has a few pricey NOS pieces. Aftermarket lists for 1982-1983 Mirada only....is there a difference? Chrysler used that same looking handle on a lot of models for many years..... Any help...
  2. MiradaCMX80

    Magnum Build Advice Needed

    Well....I have my little 318 running good, and have been driving the car a lot. Meanwhile, one of my friends is spending my money quickly. I have two 360 Magnum truck engines coming to me for dirt cheap. One is a 96, the other a 2001. I also have a new in box set of Hooker headers that fit my...
  3. MiradaCMX80

    New Fuel Sender Wiring Help

    Mopar 80 81 82 83 Cordoba Mirada Gas Fuel Sending Unit # 4051399 NEW | eBay I purchased this fuel sender for my 80 Mirada because after testing the chassis wiring and gauge, I believe the aftermarket sender in my tank is bad. Furthermore, the aftermarket sender doesn't utilize the wire for...
  4. MiradaCMX80

    Fuel gauge help

    My 80 Mirada has a new gas tank and sender unit. But the fuel gauge doesnt work. I just took the tank out of the car, and saw a wire hanging. The sender harness has a green wire which was the wire dangling, a blue wire to the sender post, and a grey wire hooked to the spade terminal of the...
  5. MiradaCMX80

    EGR Time Delay Box?

    On the firewall of my 80 Mirada is a red box with a 3 wire connector. It's next to the voltage regulator. Is this the EGR time delay box? My EGR and smog junk is gone, so I'd like to remove the timer if that is it and relocate my ignition coil to this spot. I'm sorry, but don't have a picture...
  6. MiradaCMX80

    Tach hookup

    Stopped to get an Equus tach today. I was reading on an A-Body forum that hooking the tach lead to the coil negative can make the tach jumpy due to possible RF interference. The answer is to hook the tach lead into the grey wire on the distributor instead, and run the positive for the tach...
  7. MiradaCMX80

    80 Mirada 318 tweaks

    Hi, New member..... I just brought home my 1980 Mirada CMX 318 2 barrel. I'm already planning and tinkering. First thing I want to do when it's registered and insured is get it to my local exhaust shop for 2 1/4 H-pipe dual exhaust. The Y-pipe is leaking and the pipe right behind the cat is...
  8. MiradaCMX80

    Introducing New Member: MiradaCMX80

    Mopar nut, recently bought a 1980 Mirada CMX. Found this site while researching. Looking forward to talking with other Mopar folks, and learning about my unusual vehicle! Location: Michigan
Back
Top