Found an 87 Dip AHB in a scrap yard what to get?

[YY1]

I know I've seen this list before.

I know I want the steering box.

What else?

It has a non-lean burn 318.
IIRC, there is a "162" sticker on the valve cover.
My 5th Ave has a "121". What does the 162 mean?

I don't have an F/M/J, but I do have a 66 B, a 73 and a 74 B, and I'm going to look at a 1970 Duster.

What all of those cop goodies will work on those cars?

 

[slant6billy]

11 inch brakes..... forget that. grab the whole suregrip (posi) rear and leafs, brakes and all. 125 speedo. What area of FL are you in? I've got people in Tampa and Orlando, and Daytona. They are all MoPar people too.

 

[Aspen360]

That should be a roller motor also. Swirl port heads

 

[DCAspen]

PS cooler,oil cooler,front and rear sway bars,oil pressure gauge,125mph speedo,remote trunk setup,interior dome light,26"radiator and fan shroud and thermal clutch fan.

 

[YY1]

Are the heads any better than my regular 1987 302s?

rad is gone, fan is gone.

Didn't think to look if SG. Will do so when I go back.

Believe it or not, all I was looking for was a metal trans line so I didn't have to bend one myself.

The counter girl almost talked me out of going to look 'cause "we ain't got nuthin' like that back thar, unless you mean a Con-cord".

There's a /6 4 D Aspen next to it, and an 84 /6 full size truck.
Does that truck have a hardened seat, hydraulic lifter head?

Will that rear sway bar work on my 73/74 Chargers?

 

[ramenth]

If you're grabbing the oil cooler don't forget the lines with the block at you can tee out of for a gauge and the idiot light switch, both, too. Grab the hollow bolt for the fuel pump the oil return line runs to. It allows oil to spray in on the timing chain.

Grab everything on the disk brake set up, including the hoses and the calipers, the spindles, etc. You can use those on any number of cars in the alphabet.

 

[holmes]

Are the heads any better than my regular 1987 302s?

rad is gone, fan is gone.

Didn't think to look if SG. Will do so when I go back.

Believe it or not, all I was looking for was a metal trans line so I didn't have to bend one myself.

The counter girl almost talked me out of going to look 'cause "we ain't got nuthin' like that back thar, unless you mean a Con-cord".

There's a /6 4 D Aspen next to it, and an 84 /6 full size truck.
Does that truck have a hardened seat, hydraulic lifter head?

Will that rear sway bar work on my 73/74 Chargers?

Does the truck still have the complete spare tire carrier (both rods, carrier and adjustment sleeve/nut) under the back of the bed?
If it does and you could snag it and ship it to me I'll pay all expenses for your trouble.