9secRR's latest activity
-
9secRR replied to the thread this is what i'm busy with.Waiting for a friend to get back from holidays. He has a set of 1.75 ratio rockers I want to try. -
-
9secRR replied to the thread this is what i'm busy with.that's what i thought but wanted to make sure. i have Dykes rings so that might be different gaps then standard or gapless?
-
9secRR replied to the thread this is what i'm busy with..0045'' top gap? and only .005'' for 2nd? bore size X the .0045'' and .005''? bore X .0045'' for top and 2nd ring gap with no boost or...
-
9secRR replied to the thread this is what i'm busy with.exactly. the world has become ''overthinkers''. i like the keep it simple
-
9secRR replied to the thread this is what i'm busy with.yes top and 2nd ring gaps the same. i follow the instructions from Total Seal. bore x .0045'' for both top and 2nd. in my case that's...
-
-
9secRR replied to the thread this is what i'm busy with.Couldn’t resist putting heads and intake on.
-
-
-
-
9secRR replied to the thread this is what i'm busy with.Rings are filed, new rod bearings. All that’s left is to check rod bearing clearances. Should have pistons in the block tomorrow
-
-
9secRR replied to the thread 77 Aspen R/T Colour Change.looks good Brad.
-
9secRR replied to the thread this is what i'm busy with.As I mentioned, nothing goes according to plan. Not much time yesterday for the 414. I went and helped my son in law get his super comp...
-
-
9secRR replied to the thread this is what i'm busy with.So far it’s run 9.61 with a horrible transmission and converter. The trans blew to pieces the next weekend. This is the cuda it’s going...
-
-
9secRR replied to the thread this is what i'm busy with.Since the 416” ready for the run stand, I will have time to work on the aluminum 414”. If all goes well, I should have the short block...
-
9secRR replied to the thread this is what i'm busy with.Pretty much got it wrapped up. All that’s left is to put oil in and prime the oiling system. Then it’s gonna get loud.
-
