Recent content by Ash_Whole

if it is glowing the compressor is too tight. usually a clutch goes bad when the compressor is bad

i cleaned it up a bit, the boogger welded over it. then welded back the perch. the axle only need to be there another year'ish before the 8.75 goes in.

i could not keep oil in my diff. a constant leak from the right axle tube. pulled the axle, cut the perch off. found it.

well it was an eventful day. went to the shop to get it tuned. ~40km highway drive, with 3.90, so basically 3300rpm and 90km/h. then started running like shit the hotter it got. cooled off and ran OK. once it was strapped in, ran on 6. found #5 and #7 plug melted on the header. even with the...

once it is running, im getting it dyno tuned. no point wasting all this money and not getting 100% put to use

finding a place for the parts is kinda hard. the way it is all laid out, everything needs to be on the left side of the car for the harness to fit, but the F body does not like that. also the distributor is slightly too big to fit with an aftermarket manifold. needed a slight adjustment. i...

it's been i while since i wasted money, so here goes. never ends well with a box from Summit

cop wheels, front 255/60/15 rear 275/60/15

The 2023 Dodge Challenger SRT Demon 170 weighs approximately 4,200 pounds.

just big boned

google seatbelt rebuild service

bent axle flange? loose u-bolts for the axle?

Steering Idler Arm Moog K7086 | eBay found the above on EBAY, is this a good part? tried googler but nothing looks like this. removable end other side looks like it has a bearing

is this worth the money? i idle arm is worn pretty good, i need a new one. the police/taxi ones are long gone. at $200 are these worth the money? Firmfeel Mopar Suspension and Steering

ZJ exhaust manifolds fit.