I have a problem (again). My Mirada with front disc / rear drum brakes had rear axle removed and brake lines re-done. In the process I (by forgetting to block) ended up draining a major amount of the rear brake hydraulic system.
I added brake fluid to the empty container of the master cylinder...
OK, so I run into problems, and quite a bit too.
I took away the floor mat and I found out the drivers side footwell floor (and firewall up to the seam) is in quite a rough shape. The driveshaft tunnel and sides seem to be solid!
Any suggestions about finding new footwell floor panels or...
My -83 has undergone some pretty wonky re-wiring and I am currently renewing them a bit.
The question is: are the wires in the circled part just positives split from main cable to multiple smaller ones? So I could remove the original "lump", add one proper busbar or fuse box and split them up...
The mystery is unfolding, to a degree.
The problem is (in theory) that the arm turning the mechanism does not stay in the pivot point (the rectangular base of the lever itself). These are seen left-most on the second image. When the lever is turned clock-wise it should turn the plate behind all...
Hello!
Sorry if this post seems hard to comprehend but I'll try my best.
Anyone have insight about the latch and/or release system on passanger side? The seat moves front and back from the release lever from the front under the seat. But the lever to flip the seat over to allow entering the...