Recent content by Michael Joseph Moynihan

I have a 78 Volare premier with the Super Six and chased a exhaust leak down to the gasket between the intake and the exhaust manifolds where the heat riser is located. Gaskets were gone 1/2 of the way to the inside towards the head. Removed both blasted and all new hardware as well as gasket...

Thanks for the help

Are the key lock for ignition switches the same for tilt and non tilt? Also how hard is it to replace. Mine jammed up and I could not turn it off. Had to use rag to carb to stop engine. I did get it back and key out but it was very tight

I replyed from another post, wondering if this is still available or has been sold. Thanks Mike.

Anyone know of a place or service that can do repair to my tilt steering wheel. Plastic is cracked and the woodgrain trim ring is flaking off. I have looked on line and even sent pictures to a few shops but they all tell me that they don't do that particular model. I do know that the tilt wheel...

Not sure if this helps but I had to get a one for my 78 Volare because when the headliner was done they cracked it. Tired to repair but no go too brittle. Found out that Dakoda trucks have the same lens that fits only differance I see is my original base is metal and the truck has a plastic base...

After having my BBD rebuilt and adjusted it has gas dripping out of the booster when running. Strong gas smell all the time. Anyone know what can cause this? Thank for any help

Thanks I will give it a try

It never idled good before or after the gaskets were replaced. Has the same after the carb rebuild and all the other items done. I think that it in ignition wiring from the module to the distributor. It just acts like a something is arcing across to a ground.

purchased in 2017 with 75K original miles. Exhaust manifold gasket leaking at back #6 port. Had it replaced by a friend who is a Mopar Man and no leaks when done but did not idle well. 2018 original distributor complete rebuild and recurved, new cap, rotor, plugs, wires and belts. Still not a...

Carb is the original was leaking around the bowl gasket, pull off is new as is the intake/exhaust manifolds. I will check the vacuum lines for leaks. Thanks

Thanks for the information. I had considered this option but wanted to keep it as stock looking as possible.

thanks for the information.

I have a 78 Volare Premier with the Super Six that has a Carter BBD 8137S carb tag. Base is casting 2543 with main metering jet .086 and has metering rods 2228 .0665x.0635x.056. I have carb apart and cleaned but the venturi assembly is damaged on one side. Looks like it was tried to be removed...

Hello to all, I am Mike and have a 78 Volare Premier 4 door that I have had for 3 years. I have updated the radie and 8 track and added upgraded speakers, nothing else. Car is all original and everything works including the cruse control. In process of rebuilding the BBD but need some help with...