jed_laski
Member
Hi! I have been replacing my oil pan gaskrt recently wich involved rising engine etc. so had to loose alternator support/water pump bolt. Wich i didnt know that it goes through and holds water load. So i bought a ramrod from a gun shop and started to clean the bolt.thread to apply loctite etc. What happened is that the crappy ramrod brush loosened, spearated from handle and stuck inside. After numerous tries to pull out i accidentally pushed it inside. At first i was panicked, but later i remembered that i have bare 5.2 magnum block and inspected the area where it has gone and found out it may not interrupt anything. So how do you think guys, is it okay if it just stays there forever until rebuild and pulling the caps out? I doubt that it can go into water pump because of brush. The engine is 318