FOR SALE Reproduction Alignment Spacers for FJM's 4014352 & 4014353

[slant six]

Hello, is there any interest in getting some MoPar 4014352 & 4014353's made? (as shown below)

I can draw these up in CAD if someone else has not done so, and get a few sets of them cut. I will make them in 1/4" thickness, as they were from MoPar.
(2) 4014352 & (2) 4014353 are required per vehicle.

After I get a set drawn and made, I can determine the pricing and shipping.
Please share your interest in this thread below.
Thanks,

Greg

4014352

4014353

 

[Camtron]

Priced making these with sendcutsend.com, can get them done for super cheap.

 

[DCAspen]

I would be interested in a set of these alignment spacers.

 

[DCAspen]

Spacers

 

[slant six]

Priced making these with sendcutsend.com, can get them done for super cheap.

I am not sure what your dollar amount is for super cheap?

It seems that they are only super cheap if there is some volume to them.
One Set of 4 spacers in 1/4" Mild Steel from SCS is $31.37 plus the Shipping fee; pricing as of 4/14/26

There would need to be some volume here for it to make sense to continue with the project.
@DCAspen
Send me a message, I can certainly get these made for you, but pricing would be high. As I said earlier, it would make more sense if I could get a few more folks interested as well to get a better price for the parts in bulk.

If I can get 10 orders for a set of 4 spacers, I can get them made and shipped to you for $25

Thank you for your time!

 

[Camtron]

You upload your dimensions to any of the many online chop shops (like sendcutsend.com) and then you’ll have your part in the mail in a few days. When I priced a set during Covid it was about $47 w/ shipping to have a one off set made.
Having parts made is easier and more affordable than ever before.

 

[Camtron]

You upload your dimensions to any of the many online chop shops (like sendcutsend.com) and then you’ll have your part in the mail in a few days. When I priced a set during Covid it was about $47 w/ shipping to have a one off set made.
Having parts made is easier and more affordable than ever before.

Which mind you, I’m not pointing out a flaw or issue with your post or anything, just pointing out it’s much easier and cost friendly than previous years to get one off or small batch parts made without breaking the bank these days. Cheers