Latest activity
-
IInfiniti Dave replied to the thread 360 Oil Filters ?.I believe the 3.66" number refers to the filter diameter, same as the Mopar filter. That's where the problem is getting it in. Need...
-
The remote filter is the way to go long term. So much easier for oil changes. No mess, easy to get to, and you can mount it somewhere... -
66PKRTSE replied to the thread this is what i'm busy with.Should have not gone through the fender at all in my opinion, but since it is already done. It looks okay as is.
-
M_Body_Coupe replied to the thread 360 Oil Filters ?.All WIX filters: 51335 2.483" by 3.660", 3/4-16 thread, by-pass valve 8-11 psi, drain-back valve, 280 psi burst pressure, 7-9 GPM Flow... -
Natural, at least. I think it would look tits with a polished stainless pipe and hardware though.
-
Leave them as is. Gives a nice little touch at the pipe. :)
-
Duke5A replied to the thread this is what i'm busy with.Natural, at least. I think it would look tits with a polished stainless pipe and hardware though. -
69- replied to the thread this is what i'm busy with.Leave them as is. Gives a nice little touch at the pipe. :) -
9secRR replied to the thread this is what i'm busy with.Changing things up. Should I paint the rivets black or leave them aluminum? -
-
Gotta get them out everyday -
LSM360 replied to the thread 360 Oil Filters ?.The remote filter is the way to go long term. So much easier for oil changes. No mess, easy to get to, and you can mount it somewhere... -
Vvolare 1977 replied to the thread 360 Oil Filters ?.Mopar made a shorter filter than the standard 3549957 shorty but I don`t remember the part number on it. I think it was for marine...
-
VJust taken off...all hexheads except for the two screws that are to the left and right of the cluster...These are in horizontally.. a...
-
Just taken off...all hexheads except for the two screws that are to the left and right of the cluster...These are in horizontally.. a... -
JackVolareBeep replied to the thread Dash Pad.Just taken off...all hexheads except for the two screws that are to the left and right of the cluster...These are in horizontally.. a... -
