Sub03's latest activity
-
Pickup completed, the hood is on it's way to it's new home in Ocala. Thanks Charlie, it was great getting to see you again. Thanks to... -
In general, no. You might install them and button up the engine, and it might even run, although not well, and maybe not long. The cam...
-
My 77 LeBaron has been through a lot of rebuilding. Last item was to replace original valve stem seals. 146,000 miles on engine but...
-
Sub03 replied to the thread Repair bearings.Could you explain how they didn't fit? Are you sure you mounted them the right way? The seal should go in towards the diff, the widest...
-
-
Sub03 replied to the thread Repair bearings.They fit just fine. I put them (actually the Centric 41468000) on my Aspen's 8.25 five years ago, no issues.
-
Hello, I am Scott from north Iowa and I am now the owner of a Dodge Super coupe
-
Hello everyone and greetings from Finland! As some of you know, it is the "happiest country in the world", but not so happy because it...
-
Sub03 replied to the thread 1980 Volare Cop Car.That looks familiar. This is what I found a couple of years ago when I did my rear end: At least I finally got rid of the clunk in the...
-
-
Alright folks. I hate to pose a problem and not follow up with a solution, so here goes ! Hedman Headers sells " Header X-Tensions that...
-
-
Sub03 reacted to Voeltagear's post in the thread Light throttle ping from stoplight on hot days with .I know this is an old thread but I thought you guys would appreciate an update. One thing that turned out to be a problem in the...
-
Sub03 reacted to Andrew1980's post in the thread WANTED Looking for a Walker 40430 “Canadian Y-Pipe” with .I'm happy to report that I was able to get a Walker 40430 Canadian Y-Pipe from Waldron's exhaust! Ruth at Waldron's was very helpful...
-
Hey everybody, I own an 87’ fifth and I have some questions for all you mopar heads. I’m very familiar with GM and pretty handy when it...
-
Sub03 replied to the thread Miller Tools.I see, of course I did manage to read it the wrong way. :D I can't help you with the cup size (!) for the lower joint, but I don't...
-
Sub03 replied to the thread Miller Tools.Are you shure the upper ball joint is pressed in? Did the front end on my Aspen a few years ago, and it did have threaded style upper...
-
