Search results for query: *

Link: TRW 12372A Torsion Bar Bushing | eBay These are getting hard to find and I won't be a hoarder and buy this one. So if anyone else needs one here it is. Is the price high? yes, absolutely, but I haven't seen one pop up in almost a year.

Belated Happy Thanksgiving everyone

This site loads photos the wrong way sometimes. It's happened to me. It'll happen to you too eventually.

it's dripping down from somewhere. hose or radiator pin hole maybe. depends how bad it is. check where your over flow discharge is pointed too. if your system is over full or over heating it could could just be from the over flow

I have doubt that it'll fit in a flat rate box

Anything at the hardware store would be of better quality. They're just cheap stamped nuts.

The seat tracks have studs that go through the floor and there are 4 nuts with captive washers under the car that hold the seat track studs to the floor. the cat heat shield is held in with cheap nuts that will break off if you need them to break off. The cat doesn't need to come out. If i...

Do you really need a set? You can replace the whole ISO set up with B body plates: Iso-delete Options

This guy has a pretty good set of pics of one torn all apart: Post in thread 'Torsion-Bar nightmare' Torsion-Bar nightmare I don't know how people get these off the ends of the bars without ruining them. I figured they all "rust weld" on after so many years. If all else fails and you need to...

Agreed. It's probably just a valve cover gasket

I removed the steering box valve to make it easier to get my power box out so I wouldn't have to try and remove the pitman arm. I wasn't reusing the box anyways. I still have the factory exhaust. I didn't have to remove any of the factory exhaust at all.

The one with the bolt in it is probably an aftermarket replacement, like Moog, so someone has been there before.

Your thermostat and/or water pump is bad and you're seeing the rusty coolant from the block force itself through the old seals as the car heats up.

a 20 second quarter mile car.... even the police diplomats did it in 17 seconds!

"Grille closure panel" I've always called them header panels

Caprice/88/Bonneville?

You'd need the fiberglass header panel off the Aspen, but yeah, 80 Aspen front clip should fit on an 81 Diplomat.

WNY/Southern Ontario would out of the way if you're driving from NYC to Cleveland. The roads will be jammed with cars this week with people traveling.

Is it too cold and wet to work on your FMJ today? Enjoy watching someone else suffer with one of these cars!

Free 7 1/4" In WNY Driveshaft included If no one wants it, I'll chuck it on the scrap pile. Which is what will probably happen.

Looks like you have your high beams and low beams swapped You need to escalate the problem higher up the chain with safe light. Otherwise they'll just wait until you go away. It honestly sounds like they bullshitted you until they think they won. I wouldn't have left the shop with that broken...

If you detour North on your way to Michigan, I think you'll pass by me, @Mikes5thAve and @M_Body_Coupe

Link: [FOR SALE] - Cop car rallye wheels One of the guys on FABO has a usable set of 4 police wheels for sale