Search results for query: *

  • Users: dkamp
  • Content: Threads
  • Order by date
  1. D

    Fuel Sender Sock.

    On a Fuel sock, if it is pointing down at a 45 degree angle, will it suck gas at the bottom of the tank as the sock is exposed to No gas, but the end on the sock is still submerged in gas? or will it stop sucking gas as soon as the level reaches the bottom of the metal tube portion? Inquiring...
  2. D

    TorsionBar End Bushings

    I am in process of obtaining polybushings #1100 and #1102 I dont understand and hope someone can help me, I've read so many posts recently about the troubles getting the rivet drilled and pressing off the end bushing. Is there any problems you can point out to me if I remove the torsion bar...
  3. D

    Alternator Bearing replacement question

    On a square back alternator, when you press in the new bearings, how do you know how far to press them on?
  4. D

    AC Leak detection

    I have a slow leak in my AC. (Not factory, This is a Vintage Air System). A visual check looks all good, no oil residuals I could find. Since I could not find any potential leak points anywhere, I replaced the O-Rings in every connection I could physically get to. I then pulled a vacuum for 30...
  5. D

    Sensitive Steering

    77 Diplomat, It has very sensitive steering. Is there any thing that can be done to make it NOT so sensitive?
  6. D

    "Chrysler Distributor Bushing Installer Tool"

    Would anyone consider Loaning/Renting me the Bushing Install tool? I could send you a PayPal $150 and when you get it back from me, you send me the money minus your rent fee. David
  7. D

    Harmonic Balancer Question

    I was wondering the need to replace a Harmonic Balancer/Damper on a Stock engine? How do I know "when" to replace it other than the obvious physical damage? If the rubber has very small cracks, is that a reason? I'm replacing the Timing chain set now, is that a reason even if no scoring on the...
  8. D

    Mopar to GM Ignition conversion

    I have a 318 with a two wire Distributor without points. I'm currently running the Mopar ignition (4 wire Orange Box, 1 Ballast resistor, and factory Oil filled coil). I want to change to a GM HEI system with no Ballast, but have a few stumbling blocks that I need to overcome first. If I go to a...
  9. D

    Column ID help please...

    I have a steering column I was told it was MFR by Saginaw and is from 75-76 Chrysler New Yorker or Large Chrysler, or Eldorado Style Has anyone actually seen this column on a vehicle? I'm trying to locate the parts so that I can get the Telescopic feature to work again. I need the two parts in...
  10. D

    Distributer Vacuum

    On a 318 with a Edelbrock 1406, with no EGR. I have the ported vacuum (Passenger side) going directly to the canister on the distributer. and the driver side port blocked. Is this correct?
  11. D

    Distributor gear play on 318

    On a 318 where the distributor sits, the gear slot has play in it. I put a large flat tip screw driver in that slot and could wiggle it a bit. how much play should that have? None, or do I have a potential issue? I only ask because when I have a Timing light on it,. the mark jumps around a...
Back
Top