volare 1977
Well-Known Member
Does someone know what these tools are for? I think they are miller trans tools of some type. I want to sell them but I would like to know what they do.
Miller trans tools ID
- Thread starter volare 1977
- Start date
Aspen500
Well-Known Member
Are there any numbers on them? I see one on the tool with the 2 screws but can't quite make it out. The tool on the right APPEARS to be some sort of forcing tool to install bushings or bearings(?) I see the thrust bearing which is more like a pulley installer. Only a guess.
The other tool, no ideas at all. Are you sure they're for transmissions?
The other tool, no ideas at all. Are you sure they're for transmissions?
volare 1977
Well-Known Member
After some help and research I found out what they are for. The C3289 is superseded by C3529 which says it is for powerflite and 56 chrysler 3 speed trans. It is used for the servo spring compressor. The C-708 was shown to be for a fluid drive trans for runner hub bushings installation and burnishing.
Koolkar57
New Member
3/26/26
Hello Volare 1977 ,
I am currently overhauling the cast iron Torqueflite in my 1960 Imperial that lost reverse .
If you still have the C3289/C3529 band servo piston compressor tool pictured here , with the two knobs on bolts attached to the bracket that holds it to the case for depressing the servo pistons, I would buy it if it is for sale and pay the shipping , it would be a great help.
I have the cast iron push button Torqueflite in my 60 Imperial and an aluminum 64 pushbutton Torqueflite in my 46 Dodge street rod coupled to a 54 Dodge Red Ram 241 Hemi.
Thank you , Kerry Ming cell / text phone 214-837-8117
Email : kermit74p@msn.com
I live in Justin , Texas about 5 min from Texas Motor Speedway .
I found your post searching for that tool and just registered on this forum username Koolkar57 to message you.
Even if you could give me the dimensions spacing between the two bolts and the mounting hole dimensions I could possibly fabricate something that would work if it’s not for sale.
Thank you
Hello Volare 1977 ,
I am currently overhauling the cast iron Torqueflite in my 1960 Imperial that lost reverse .
If you still have the C3289/C3529 band servo piston compressor tool pictured here , with the two knobs on bolts attached to the bracket that holds it to the case for depressing the servo pistons, I would buy it if it is for sale and pay the shipping , it would be a great help.
I have the cast iron push button Torqueflite in my 60 Imperial and an aluminum 64 pushbutton Torqueflite in my 46 Dodge street rod coupled to a 54 Dodge Red Ram 241 Hemi.
Thank you , Kerry Ming cell / text phone 214-837-8117
Email : kermit74p@msn.com
I live in Justin , Texas about 5 min from Texas Motor Speedway .
I found your post searching for that tool and just registered on this forum username Koolkar57 to message you.
Even if you could give me the dimensions spacing between the two bolts and the mounting hole dimensions I could possibly fabricate something that would work if it’s not for sale.
Thank you
