MY3033
Active Member
Looking for some insight on how I can route some belts. My Aspen is a factory AC car, but compressor is junk, pulpy turns, clutch doesn’t. Do I have to run the compressor just to have the belts fit?
I have a different 318 core engine that runs a belt for the water pump and alternator only. I would like to go to that set up.
Attached are pics of my engine as it sits. I see the water pump was driven off the smog pump belt, my air pump is siezed up, so it will also be going away.
Long story short, I would like to run just the alternator, water pump and power steering pump. Will retain the ac compressor if I have to. I’m assuming I’ll need to swap some pulleys?
I have a different 318 core engine that runs a belt for the water pump and alternator only. I would like to go to that set up.
Attached are pics of my engine as it sits. I see the water pump was driven off the smog pump belt, my air pump is siezed up, so it will also be going away.
Long story short, I would like to run just the alternator, water pump and power steering pump. Will retain the ac compressor if I have to. I’m assuming I’ll need to swap some pulleys?