Hemi RT aspen Wagon

hemijoe

Well-Known Member
Joined
Mar 19, 2014
Messages
85
Reaction score
63
some more progress today got the master cylinder installed and plumbed in fan installed and fully wired ground cable changed fuel lines and filter installed
now i move onto the trans filter and gaskets drive shaft and exhaust

100_2239_zpsaxrn8bfa.jpg

100_2238_zpsqdntznqd.jpg

you can see the ride height that needs to be lowered way too much space above the wheel

100_2235_zpsmxlcgeds.jpg

100_2237_zpsa0inxooz.jpg

100_2234_zpskkjdgwov.jpg


100_2229_zpsvd75golw.jpg


100_2232_zpsdnoqundw.jpg

100_2228_zpsgmn3jakh.jpg


another good pic of how high the front sits
 

Darth-Car

Well-Known Member
Joined
Aug 9, 2015
Messages
880
Reaction score
351
Location
Ohio
With that ride height you could drive down the road with the front of the car bouncing off of the pavement. A little lift fropm the wind, and a bouncing you would go.:D
 

hemijoe

Well-Known Member
Joined
Mar 19, 2014
Messages
85
Reaction score
63
well here it goes first start not the best vid but its a start this is the fisrt time the engine has been started so there are setting to be done like floats need to be set timing and exhaust needs to be installed this was a test fire only
 

hemijoe

Well-Known Member
Joined
Mar 19, 2014
Messages
85
Reaction score
63
time for an update gallipin Gerdy got a Xmass gift a new set of carbs 1404's and now its runnin absolutely the way it is supposed to
100_0214_zpsyskipiqy.jpg

100_0208_zpsn3jvhjso.jpg

100_0206_zpsmt0ahwvo.jpg


here is a clip of the new run
 
Back
Top