Since this is my only car, my plan is to make sure I can power the seats and then run a properly fused supply line into the seat area before starting on the physical anchoring. On these seats, there is a bottom and a top half to the mounting system. Bottom half bolts to the frame, top half bolts to the seat and slides - the two halves bolt together with a spacer in between. I'm hoping to take the bottom half of the existing seat hardware and create bolt through holes so that this top half can drop right on it. I may need to alter it for height using longer or shorter spacers or by modifying the lower bracket. In any case, I'll be going to a professional welding shop to help fabricate whatever is needed. Mainly because I don't have a welder at the moment, am out of practice at welding, and need my car daily. This will ensure I don't screw something up and put my car out of commission.