Ash_Whole
Well-Known Member
i have an older Torquer II. works good, but no air cleaner that can fit. i dont want to chop up the hood so i need a replacement that fits with an air cleaner.
What is the best 360 manifold that fits under the hood with an air cleaner?
- Thread starter Ash_Whole
- Start date
AMC Diplomat
Well-Known Member
M_Body_Coupe
Well-Known Member
For what it's worth, take a look at these compares of my assortment of intakes:
1) http://darcio.no-ip.org/mopar/intake/intake_compare_front.jpg
2) http://darcio.no-ip.org/mopar/intake/intake_compare_rear.jpg
3) http://darcio.no-ip.org/mopar/intake/intake_compare_top_front.jpg
4) http://darcio.no-ip.org/mopar/intake/intake_compare_top_rear.jpg
1) http://darcio.no-ip.org/mopar/intake/intake_compare_front.jpg
2) http://darcio.no-ip.org/mopar/intake/intake_compare_rear.jpg
3) http://darcio.no-ip.org/mopar/intake/intake_compare_top_front.jpg
4) http://darcio.no-ip.org/mopar/intake/intake_compare_top_rear.jpg
Ash_Whole
Well-Known Member
thanks. what are the two on the left?
has anyone tried those chinese 360 intakes with dual bolt patterns, they say air gap in their names, i assume its a knock off of a performer air gap.
volare 1977
Well-Known Member
Have you tried different drop base chrome air cleaners? Some have more drop than others.
Ash_Whole
Well-Known Member
I have less than 3 inches between the throttle body and hood
volare 1977
Well-Known Member
you should be good with a drop base air cleaner, research them online
I got the Professional Products cross wind dual plane intake (#55026) on a 5.2 magnum.
For the price I got no complaints, but this is a stock Mag in an Aspen used mostly with a light right foot on sunny days.
My only regrets is that I didn't check the port matching and casting burrs i've seen mentioned in the reviews before installing it.
But it seems OK for my use.
Dont have the car here now for measurements, but I'm guessing 6-6,5 inch hood clearance from the intake.
Carb height is 3,25" + 3/8 base plate + 2" spacer + ~1" top hat
The pictures shows my setup. I used the magnum "top hat" with a 2" spacer and a remote air filter.
I later cut of about 1 inch of the spacer because the plastic top hat got some scratches after rubbing against the hood bracing.
LSM360
Well-Known Member
What car is this on? I have an '89 Diplomat with an Air Gap intake and factory 4 barrel air cleaner and hood closes.
80mirada
Well-Known Member
Crosswind, stock 5.9 Magnum, wit a Lunati VooDoo cam. I run a stock air cleaner, and it does touch the sound deadener pad
M_Body_Coupe
Well-Known Member
Mopar LD340 and Edelbrock Performer RPM (the original style without the divorced runners).
Here is one more pic =>
