input on scat I Beams for 360

80mirada said:
There are usually sets of reconditioned rods on eBay for sale
Click to expand...
I knew a guy that put a lot of reconditioned parts on Ebay, his machine shop was failing because of his lousy work reputation so he would crank out sbc parts. Heads, rods and short blocks until those parts started having trouble.
Cheap Ebay parts might be expensive in the long run.
 
Usually the sets on eBay are TRW reman, there were a bunch of new Mopar sets from the Cummins reman/crate engine operations for a while, but those seem to have dried up
 
I wish I had bought the 360 crate motor rods (cummins) and I think they were not much more the $100 if I recall. They were there for a while.
 
At this point I've decided on Eagle I beams with a press pin design, Federal Mogul .040 cast pistons -its a 74 318 motor and an Eagle cast steal crankshaft
 
Have you been able to source the press pin rods? I ask because here in the states they are very very hard to find or unless they made a recent run which I doubt.

Have you thought about a hyper piston with more compression since your going to spring for the crank and rods?
 
I talked to Eagle or somebody that said the press fit rods and cast steel cranks should be in the works again -maybe August. I'm staying quite origional or I might as well stick in a crate motor like everyone else
 
You must log in or register to reply here.
Back
Top